I just purchased a set of '04 Kawa Ninja rearsets off of Ebay to retro fit onto my GS.
I was thinking about having aluminum adapter plates machined, but I think it'll be too expensive and take too much time.
My question is: If I just make the adapter plates out of steel, what thickness would I need to get to insure that these will be safe and sturdy for the long term?
Any other suggestions or alternative solutions are welcome.
DB
I was thinking about having aluminum adapter plates machined, but I think it'll be too expensive and take too much time.
My question is: If I just make the adapter plates out of steel, what thickness would I need to get to insure that these will be safe and sturdy for the long term?
Any other suggestions or alternative solutions are welcome.
DB