M.B Co
Coast to Coast
Running a DCC 7"Headlamp, DCC ears and some LED turn signals. They are studded so they thread into the bucket through the ears. I can tighten them down pretty snug without damage to the lights then run a nylon nut on the threaded stud to cinch to the inside of the bucket. Yet, there is still a little movement if I put some pressure on it.
I don't think it will move during riding but I want to have a precaution when/if it does.
Thoughts on drilling into the bucket and ears to put a small allen set screw in?
Example:
I don't think it will move during riding but I want to have a precaution when/if it does.
Thoughts on drilling into the bucket and ears to put a small allen set screw in?
Example: