I have checked with KZ440, the rearset is fit for the KZ440. However, I believe that (excluding the rod size that I do not know) the rearset will fit very good on KZ650 as KZ650 having full clearance for it to work on. If you want, pls send me your rod measurement, I will make 1 set of rod for you.78KZrider said:These look great. I am wondering if you know if they will fit on a '78 KZ650B? These would really do the trick on my cafe build.
Send me your measurement, it takes few hours to complete those rodsrocketman said:Viet, I'll get some KZ650 measurements up sat night for you. I'd be looking for a complete set rods included!
Dear Dawdish,dawdish said:Hi Viet, I've been reading through the posts, and I'm impressed with the versatility I see in the product. I have 2 bikes a CB400F and a CB500 Four and of course am looking for a good clean setup for them, do you think yours would be a good fit?
Viet said:Dear Dawdish,
I have research on CB400F and CB500F. First, you could mount my rear set to the rear foot peg position of CB400F and CB500F. Return to the clearance factor for the rear set, it needs at least 2 inches clearance from the rear foot peg mounting hole to your closest point on muffler. Second, please check on the measurements. I need your distance from rear foot peg hole to your gear shift shaft to make gear shift rod and also I need your measurement of rear brake rod (my guide is in this topic too). When you send me your measurement, I make you a bolt on rear set.
Hope to receive your support.
Viet