Apologies if this has been answered already ad nauseam (also apologies as I posted in the wrong section).
Looking to take the Honda emblem off a CB500t, strip the tank, then fill the remaining groove (from the emblem) and go from there.
Does anyone know the correct way of going about this?
I was going to use Bondaprimer, which is great stuff (I am in no way affiliated) and then a filler.
http://www.marinemegastore.com/product-BONDAPRIMER-25O-ML-AQU_Q05166.htm
Unfortunately I know for a fact that filler will soften the bonda primer and it will eventually start to peel.
I've seen a few people that have done similar filler jobs on their tanks, anyone have any idea how to go about it?
Perhaps bondaprimer, another primer then filler?
P.S. I'm in the UK hence rain and would strongly lean to anything providing zinc protection.
Looking to take the Honda emblem off a CB500t, strip the tank, then fill the remaining groove (from the emblem) and go from there.
Does anyone know the correct way of going about this?
I was going to use Bondaprimer, which is great stuff (I am in no way affiliated) and then a filler.
http://www.marinemegastore.com/product-BONDAPRIMER-25O-ML-AQU_Q05166.htm
Unfortunately I know for a fact that filler will soften the bonda primer and it will eventually start to peel.
I've seen a few people that have done similar filler jobs on their tanks, anyone have any idea how to go about it?
Perhaps bondaprimer, another primer then filler?
P.S. I'm in the UK hence rain and would strongly lean to anything providing zinc protection.