Want rearset but don't have passenger peg mount

[Nephelim]

Try looking at omars web page: http://www.rearsets.info/ they do Raaske and Tarozzi rearsets.

I fitted Raaske rearsets on to my 78 CB750 and they mount to the engine mounting bolts NOT the passenger footrest holes so i was able to cut those little triangles off.

You do need longer mounting bolts but what you buy is threaded bar stock (which unfortunatly usually comes in 1 meter lengths) On one end loctite a nut in place so it wont move or come off- this becomes your"bolt head" then put the rearset mounting plates in place, slide the bolt (threaded bar stock) through and cut it to the correct length. I used nylocs and loctited them in place as well. i was thinking of drilling the bolt and using crown nuts and safety wire but it's a bit of a pain.

So, job jobbed!

 

[ohiocaferacer]

I have the frame clamps on one of my bikes for over 10yrs and have never had them slip.
Ref the ton-up link posted earlier.

 

[evilaugust]

Ohio, where did you get the round pegs your using on your 929RR rearsets? I know they aren't stock. Do they still fold?

 

[evilaugust]

I'm wanting to replace the stock pegs on some 929RR rearsets.

 

[evilaugust]

Ohiocaferacer has what I want. He'll chime in. Calm down swivel.

 

[ohiocaferacer]

The round pegs were just some aftermarket pegs for the 929. Think they were Lockhart Phillips or something.

 

[ohiocaferacer]

Actually......think they are these pegs.
https://www.denniskirk.com/emgo/anodized-aluminum-front-footpeg.p490005.prd/490005.sku

 

[evilaugust]

Those look about right. I think they would work. Thanks.