WTB: CB360/350 starter clutch housing

looking for a new starter clutch housing for my CB360. Mine has dents in it from the pistons pushing on the outer housing so it doesnt work well anymore. I learned that the 350 and 360 use the same clutch housing so either would work. There are some on ebay but everyone sells it with the starter gear and magneto. I just need the clutch housing.

thanks!
 

ridesolo

You only bear responsibility for your own actions
thrillseeker said:
looking for a new starter clutch housing for my CB360. Mine has dents in it from the pistons pushing on the outer housing so it doesnt work well anymore. I learned that the 350 and 360 use the same clutch housing so either would work. There are some on ebay but everyone sells it with the starter gear and magneto. I just need the clutch housing.

thanks!

Pretty sure I have one for a 350 somewhere in my stuff. I'll try to look this afternoon and post up a pix.
 

ridesolo

You only bear responsibility for your own actions
OK, this is what I've got, hopefully it's true that this is the same for both 350 and 360. I have the sprocket & dogs that came out of my 360 but I left the actual housing attached to the rotor. This one came off of a '72 CB350 that I got and parted out. Check out the pix to see if you can determine if it's the same as what you need. (AND, I don't need mine so if you look at this one and it doesn't look right it would only take me a few minutes to take mine apart and get the housing for you... I'm not going to need it.)





Message me w/ your zip code and I'll let you know what the postage will cost ya.
 
Top Bottom