Search results

there are soooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo many posts on this subject. I googled it and there was an entire page of answers. You can use tons of chemicals. stuff as simple as CLR and many other over the counter products will work. Go to the...

I hope there are no speed bumps where you live. Have you checked the clearance?

looking so good. Keep it up.

I've had friends who brought their bikes inside their apartments if it is on the ground floor. Also check to see if there is any storage units near by. It can be about the same price as a garage and sometimes not too far away. If you keep it out side, Lock it up. "Keep the honest people honest"...

wish I had a buddy that could weld. where are you located by the way?

It needs to be grounded. your battery is grounded to the frame. when you touch the bike you complete the circuit.

Just read through your hole build, looks great. Keep up the good work. I'm working on my '72 cb350 right now.

i like the white one

Thanks Chris! I'm going to be running a headlight, tail light, maybe a neutral idiot light, kick only, and some of these small batteries. High/low will be a toggle switch in the headlight bucket. Do you think two or three of these would work on a cb350? I'm not sure if i'll have a LED tail...

Incase anyone was reading through this thread I've been posting updates on this site. http://www.hondatwins.net/forum/viewtopic.php?f=17&t=518&start=0&st=0&sk=t&sd=a Jason

Chris, I have no electrical knowledge but how do you splice them together?

I'm trying to see if I can find a 76 or newer Yamaha XS500 gas tank for my build. I can't find one on ebay or on Craigslist. Anyone have one laying around? Anyone have the length and other dimensions of the tank?

I'd got with the honda as well but I'd try find something like a 550 or 350. That's just me I like the smaller bikes, without oil tanks. The make the bike look lighter when you can get away with an empty mid section or some flat side covers. There is also tons of parts and info on every honda...

A Ham's and a hot dog makes any day better!

what did you use on the carbs to get that shine, paint or powder, is so what? Your build looks great I can't wait to see it complete.

Re: Not only my first project bike, but my first bike period! looks good man, I'm about where you are on my rebuild. http://www.hondatwins.net/forum/viewtopic.php?f=17&t=518&start=0&st=0&sk=t&sd=a I've found a ton of rubber and metal bit's in my engine, I only have one motor, I wish I had...

not sure if your in the US or not but just go to Sears and buy an impact driver, a set of screw removers, and a set of bolt removers. Use the impact driver first and only use the other two if you need to. Return them if you don't end up using them. From my experience, it's better to spend the...

I did some tear-down tonight I posted it on the Hondatwin.net site so here is the link to that. http://www.hondatwins.net/forum/viewtopic.php?f=17&t=518&start=0&st=0&sk=t&sd=a

I finally started on my '72 CB350 that has been sitting in my garage for almost a year. Only thing I've done so for is strip the frame down to bare metal, and I built up a engine stand. Tonight I drained the oil to see how bad it was and... the drain plug was almost a 1/4 full of metal shavings...

good luck. if you look around you'll find that you get what you pay for. Also remember if your cheap clip ons move while diving into a corner, you'll wish you spent the extra $40.