1974 CB550K Cafe Racer!!!!!

hmenzies said:
Does anyone know a good source for replacement o-rings?

Ebay has a set for cb550, or Autozone has a box of metric o-rings that I haven't tried, I think made by Dorman.
 
From my personal experience most of the O-rings (even the metric ones) for cars are too thick for most of the applications I tried them for. Just my .02
 
Soda Blasted Carb Rack with my crappy DIY sodablaster!
Before:
IMG_20120312_120622.jpg


After:
Needless to say I will be buying a blasting gun or something better.
IMG_20120312_124343.jpg
 
Made some progress today. I finally finished the rust removal on the inside of the tank. I used distilled white vinegar. Then I started on the outside of the tank. I sprayed Aircraft Paint Remover on there generously. Still took 3 coats to get it all off plus sanding and a wire brush. That paint was really baked on there. Paint is now completely stripped off the tank and Bondo is drying in the dents. I am gonna prime the tank and leave it for now until I decide on a color scheme. I'm thinking a cream color with 1 thick brown stripe on top and two small pinstripes on either side.
526391_3506539911360_1507663461_33150694_1439708847_n.jpg
 
Its been a while but ive finally gotten to rebuilding my carburetors. I got a gallon of Berryman's carb dip and had a carb in there overnight. Now my throttle valve wont go back in. I tried coating it with oil and Wd-40. Any advice?
IMG_20120331_115204.jpg
 
40 years of dirt and grime must have stained/etched the aluminum somehow. After sitting in Berryman's for 2 days and scrubbing with a scouring pad it still isn't cleaned up. Except for the throttle valve, 2 carbs are rebuilt. I mocked up the carb with the pod filters i ordered. I think it looks pretty nice.
IMG_20120331_134142.jpg
 
Back
Top Bottom