From my personal experience most of the O-rings (even the metric ones) for cars are too thick for most of the applications I tried them for. Just my .02
Made some progress today. I finally finished the rust removal on the inside of the tank. I used distilled white vinegar. Then I started on the outside of the tank. I sprayed Aircraft Paint Remover on there generously. Still took 3 coats to get it all off plus sanding and a wire brush. That paint was really baked on there. Paint is now completely stripped off the tank and Bondo is drying in the dents. I am gonna prime the tank and leave it for now until I decide on a color scheme. I'm thinking a cream color with 1 thick brown stripe on top and two small pinstripes on either side.
Its been a while but ive finally gotten to rebuilding my carburetors. I got a gallon of Berryman's carb dip and had a carb in there overnight. Now my throttle valve wont go back in. I tried coating it with oil and Wd-40. Any advice?
40 years of dirt and grime must have stained/etched the aluminum somehow. After sitting in Berryman's for 2 days and scrubbing with a scouring pad it still isn't cleaned up. Except for the throttle valve, 2 carbs are rebuilt. I mocked up the carb with the pod filters i ordered. I think it looks pretty nice.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.