jchek779
Leave the gun. Take the cannoli.
I absolutely hate to post this "is my cam timing correct" post, but I figured I'll let experience trump intuition. I've attached the 3 timing pics for the mag, exhaust, and intake cams. Take a look and let me know if I'm looking good. I had the timing marks on either side of the cam cap marks and feel most comfortable with this arrangement. As the chain elongates, the timing marks should move more into alignment.
Second question - this chain is tight. Way too tight. It'll "break in" but it's scary to think of the load this chain is putting on the cam and crank bearings. I've researched other posts that have said that this EK 29H chain is tight. Are there any decent alternatives? I'd gladly eat the $45 for peace of mind knowing that there is a better option out there.
Third question - I picked up the master link from DCC with the solid pin master links. Do any of you guys have advice on how to peen over the end of the pin without depositing metal into the cylinder head valve spring cavity?
Second question - this chain is tight. Way too tight. It'll "break in" but it's scary to think of the load this chain is putting on the cam and crank bearings. I've researched other posts that have said that this EK 29H chain is tight. Are there any decent alternatives? I'd gladly eat the $45 for peace of mind knowing that there is a better option out there.
Third question - I picked up the master link from DCC with the solid pin master links. Do any of you guys have advice on how to peen over the end of the pin without depositing metal into the cylinder head valve spring cavity?






