Re: '77 CJ360T (Café SOS) - Head and Valve Work Complete
OK... I got a bit more work done last night, but no fancy photos to post.
First up, I measured out the volume of the combustion chambers (24.5cc) and the piston domes (12.5cc) and worked out my static compression ratio. I think my head gasket is .040" and the piston sits .040" below the deck and so that brings my static compression to 11.7:1. My dad thinks the gasket might be .020" and the piston clearance is .020" as well and that's more like 13:1. Even if we split the difference, those seem to be some pretty healthy numbers. Certainly a fair bit better than the 9.3:1 offered by the stock setup.
After making the appropriate measurements, I assembled everything in order to check piston-to-valve clearances. Turns out it's tight. VERY tight. I laid down a piece of solder onto the intake valve pocket in the piston and after turning the crank over a few times (I felt the valve contact the solder) I pulled everything back apart. Unfortunately, the solder was severed by the valve. I only found out after the fact that I should have been using flux-core solder for this and so I'll need to repeat the test this evening (I'll use playdough this time). I only tested the left side as well. The right side showed no signs of contact as the carbon layer on the piston was undisturbed. Furthermore, I had the intake tappet clearances set to .003" but the cam manufacturer says to use .004" on both intake and exhaust. So that may be a contributing factor.
Finally, the .020" that was skimmed from the head doesn't seem to have made a great deal of difference to the cam timing, but I've got a degree wheel and now that I'm sure of TDC, I'll be sure to verify it. The timing card from the cam says intake opens at 16° BTC and the exhaust should open at 55° ABC and so I know what I should be aiming for.
OK... I got a bit more work done last night, but no fancy photos to post.
First up, I measured out the volume of the combustion chambers (24.5cc) and the piston domes (12.5cc) and worked out my static compression ratio. I think my head gasket is .040" and the piston sits .040" below the deck and so that brings my static compression to 11.7:1. My dad thinks the gasket might be .020" and the piston clearance is .020" as well and that's more like 13:1. Even if we split the difference, those seem to be some pretty healthy numbers. Certainly a fair bit better than the 9.3:1 offered by the stock setup.
After making the appropriate measurements, I assembled everything in order to check piston-to-valve clearances. Turns out it's tight. VERY tight. I laid down a piece of solder onto the intake valve pocket in the piston and after turning the crank over a few times (I felt the valve contact the solder) I pulled everything back apart. Unfortunately, the solder was severed by the valve. I only found out after the fact that I should have been using flux-core solder for this and so I'll need to repeat the test this evening (I'll use playdough this time). I only tested the left side as well. The right side showed no signs of contact as the carbon layer on the piston was undisturbed. Furthermore, I had the intake tappet clearances set to .003" but the cam manufacturer says to use .004" on both intake and exhaust. So that may be a contributing factor.
Finally, the .020" that was skimmed from the head doesn't seem to have made a great deal of difference to the cam timing, but I've got a degree wheel and now that I'm sure of TDC, I'll be sure to verify it. The timing card from the cam says intake opens at 16° BTC and the exhaust should open at 55° ABC and so I know what I should be aiming for.