Also finally found a location for the oil pressure switch mod I planned. This took a lot of head scratching to find the best place.
As we know full well, this engine was designed with an oil level sensor only, and had no provision for a switch. there's a few threads on the web about running extra pipework, drilling the oil filter housing, shoving in small gauges here and there, but I decided to try and keep it neat and simple. Found a small oil gallery on the front head cam feed, picked up a small pressure switch online (think it was an old British Leyland spec) rated to 0.8bar, so plenty of warning if I start losing pressure. Drilled the head in place with some strategically placed bungs to prevent the swarf getting in where it shouldn't.
Same time I took some meat off the bulky brackets supporting the engine and rear sub frame...