overdraft said:ok, both liners are out. i thought maybe there was some crap in the seats that was keeping the liners up that extra 4 thou, but no. so now i have to decide if thats close enough or if i should be trying to get the liners trimmed. i dont really want to do a bunch of unnecessary work if the gasket will take up the .004" difference, but i dont want a motor that weeps oil constantly either... and meanwhile i scorched and discoloured my engine paint, so i have to go back to the blaster and repaint as well...
surffly said:damaged the paint? you didnt use a torch did you?
uneven heat is a really bad idea
400* in the oven for a while then literally tap them into place, job done
crazypj said:They will drop when engine gets hot so you will probably need to re-torque head after first run.
The alloy shrinks further than the cast iron so you chill top of cylinders while hot, I use an old baking tray full of ice so top of block will cool before bottom, I also made a fixture to clamp liners on the XS650-800 conversions I've done