Need help identifying forks!!!

wickerRUG

New Member
Hello everyone,

Not too long ago, I purchased a 1972 CB450 and am in the process of doing a full rebuild/brat-cafe build. I've gotten to the point of rebuilding and refinishing the forks. However, I'm pretty sure the previous owner replaced the forks and I have no idea what model they could have come from.

The forks are 33 mm in diameter. The springs measure at about 19 1/8" in length, however I'm sure they've lost some of their recoil over the past 30+ years. I forgot to measure the spring diameter but can do so if necessary.

I thought they might be off a mid 70's CB360, but mine don't have the fender strut holes at the bottom of the fork lowers. Any help would be greatly appreciated!!!

I should mention the brakes are definitely not CB450 brakes. The pads that came off this bike are the same that I have on my '79 CB750.
 

Attachments

  • IMG_5963.jpg
    IMG_5963.jpg
    5.7 MB · Views: 321
They are not 360 forks, wrong type of brake mounting.
Look more like mid 80's CB/CM400
 
Great! thanks! i think you are right. Since they don't make progressive springs for these forks, is there anyway of fixing up old springs like this, apart from new fork oil?
 
Pretty much any spring of the correct outer diameter and spring rate can be used.
In fact it would probably be a good idea to go slightly stiffer sring rate. You could probably use CB350 springs but you may need spacers to make them long enough.
Another thing you could do is cut off the 'closed' coils and use a spacer slightly longer than the piece you cut off.
You will need to do some measuring first but it ain't too bad. Work out how much 'compression' you would have if spring was coil-bound (basically measure the spaces and add it up ;) )
You should be able to find suspension travel for a CB400T pretty easy (I think it's 5"?)
As long as you don't get coil binding you can chop a fair chunk off springs (they are scrap anyway so experimenting shouldn't be an issue)
Use thick wall plastic plumbing pipe for spacers, (schedule 40?) just remember to put a washer on top of spring first though and have the cut end down (unless you heat it dull red and bend it down flat)
Less working coils will give you a stronger spring so saggy front end is cured 8)
 
Back
Top Bottom