Some development of the battery tray... First a rough thin sheet aluminium version made up quick to get some sense of scale and position. Then a couple of 3D printed prototypes to fine tune the cut out and hole positions and the final flange lengths, then the final 3D printed plastic prototype - two views. These would be laser cut and bent up out of 3mm steel plate and powder coated in black if the design ever makes it into production. If enough people are interested? It is designed for either the AntiGravity or the Ballistic 8 cell (or even the 4 cells if so desired) and so that the starter relay mounts on that tab that sticks up. The relay can be cable tied in place if the rubber mounts are shot. It fits both the SR250 Specials and the SR250 Classics (re-released ones) which has a brake lever bracket to clear - hence the cut out.
I don't have time to wait for a proper prototype to be made so I made one up by hand from 2mm stainless plate. Its pretty close to the final plastic prototype but is very rough still - being hand made with a vice, hammer and hand drill. It should come up alrite once its blasted and powder coated.
You can see where it is positioned as well. Nice mass centralisation haha ;D
I don't have time to wait for a proper prototype to be made so I made one up by hand from 2mm stainless plate. Its pretty close to the final plastic prototype but is very rough still - being hand made with a vice, hammer and hand drill. It should come up alrite once its blasted and powder coated.
You can see where it is positioned as well. Nice mass centralisation haha ;D
Attachments
-
SR250_BatteryTrayDevelopment.jpg323.2 KB · Views: 481 -
SR250_BatteryTray_SS.jpg491.7 KB · Views: 462 -
SR250BatteryTrayContext2.jpg398.1 KB · Views: 490 -
SR250BatteryTrayContext1.jpg333.3 KB · Views: 450 -
SR250_BatteryLocation.jpg339.1 KB · Views: 444 -
SR250_BatteryTray_Prototype1.jpg328.7 KB · Views: 460 -
SR250_BatteryTray_Prototype2.jpg278.1 KB · Views: 464