Recent content by PMD6

Getting there slowly. All the wiring is relocated under the seat pan. Euro spec clocks still on - wiring the US spec Gl500 clocks is a little tricky to slice into the wire harness as none of the wires are the same colour and the GL500 has more. Will change the master cylinder for a...

Does any one know if there are any Honda oem spoked wheels that fitted a dual disk cx500 with 33mm forks? Including those that may need axles spacers

Reshaped the hump. Results of the second attempt below I am going to have ago at hammering some indents into the tank Sent from my GT-I9300 using Tapatalk

First attempt at fibreglassing Covered the mould in brown masking tape - then the first sheet of fibre glass In line with the instructions for beginners I only used 1% catalysts so it may take a while to dry Sent from my GT-I9300 using Tapatalk

Im planning to relocate the battery under the engine. If anyone is making and selling these items please pm me

Top yoke got chopped down - ill be using clip-ons Ill relocate thr fuse box under the seat. I hope to hide the ignition somewhere - suggestions welcome Sent from my GT-I9300 using Tapatalk

Started on the seat pan. Chopped down the original and added some ply and expanding foam to make a fibreglass mould Humps too high so needs some more shaping Sent from my GT-I9300 using Tapatalk

While the frame was away got to work on the engine Hasnt been painted yet. In the parts bin I found a new stator or chain chain guides so while its out ill do the triple Once complete it will be silver with polished covers Sent from my GT-I9300 using Tapatalk

Frame got the chop - I got this job gone by a shop as I dont have yhe skills or equipt Sent from my GT-I9300 using Tapatalk

2 weeks ago picked up a supposedly complete bikes in parts with another near complete bike. Only 1 frame had any paperwork - so on paper its a 1980 CX500 UK Spec Starting from the ground working up I cleaned up the wheels and the forks - new bearings and seal Sent from my GT-I9300 using...

Hi Is anyone making and selling the above?

Hi Looking for the above to fit 2 pot calipers to a CX500. I'm in the UK but happy to pay postage from the US Let me know what you have Cheers CR

Re: Hammering-in knee indents into a stock tank? Im also considering knocking some indents into a standard cx500 tank, however have been warned against the idea by a member of the cx forum due to the creases in the existing scallops. Is there any truth in this? Sent from my GT-I9300 using...

Having seen a few threads on here and a few videos on YouTube I'm keen to give this ago. However I have been warned on the cx forum that indents will not form nicely due to the existing scallops. Additionally I have not been able to find a picture of a CX500 tank that has had its scallops...

Re: Hammering-in knee indents into a stock tank? Thanks for the offer / help. Now that I've searched teardrop I've found them at a reasonable price. I was searching cone / bossing / forming Sent from my GT-P7510 using Tapatalk