Recent content by squirley

Just read the entire post...what an awesome build! Can you fill me in on the seat latch that you used? Thank ya much. Jens

Bike is looking great...love the black ano'd pieces.

Hello all, It has been a while since i posted here, but thought that i would add a few pictures of the cb750 build I just went through. Here's a little bit of a story, but unfortunately, thanks to imageshack, most of the build pics over the last few years are no longer available. Life...

Drewski, I am digging the zrx swingarm! If you wouldn't mind, could you tell me the pivot tube width and bolt diameter? Also what is the rear axle diameter? Any special machining for the Kawi chassis? Looking forward to more updates! Jens

This is looking great! Where did you pick up the stainless push button from?

Reviving an old thread... After being completed a few years ago, its time to give the 550 a little attention. I picked up some Works Performance shocks with ideal spring rates so I am starting with a new swingarm and shock mounts. Plan is to redo some of the tail section as well this summer...

Haha, I should have said the video clip was going to be loud! Most of the the work on my last two bikes was done in my small garage...a 4.5" grinder is a mans best friend! Finally have put a legitimate shop together, so I'm looking forward to making some high quality parts in my spare time...

You guys are awesome! Thank you to everyone once again for the support and wisdom on this board. I am honored to have been chosen out of some truly nice builds! Jens

Re: Flying J CB550 Atomic #13 Fired up Haven't seen this build for a while....WOW is all I can say, that looks absolutely amazing sir.

I want to see more NOW!

I'm digging the color and angles of the pipes! Where'd you find the battery cell? Have you tried/heard anything about its performance?

Man! I feel like I looked long and hard for a simple handlebar choke setup and I didn't find a thing! Guess I didn't look hard enough. I ended up just using the single carb pull levers and am currently making an activation bar that will tie them all together and turn them on in one movement...

All of you have been a great help and valuable resource! Here are a couple pics in its "completed form"....for now haha

No long ride reports yet, I have only cruised it around the block...little at a time haha. Here are some finished pictures and thanks for the nominations for BOTM! Jens

cobraace2 Thanks for the heads up! Gladly accepted, guess I need to put up some finished pictures. Thanks Jens