Search results

Hi all, Ive been running my '72 CB350 this summer and it's developed a bad oil leak from what appears to be the seam between the lower crank case and the left side crank case cover. Also, at the same time the leak started it's been increasingly difficult to get it into and out of gears... Any...

http://classiccycleparts.com/ Everything is sold through their ebay store but they seem to have a lot of items, even some stuff I've has difficulty finding. Tim

Hi all, At the point on the build of my '71 CB350 that it's time to rebuild the engine, which is stuck. Here's my dilemma, I was hoping to free the pistons with a rubber mallet or dead blow(just enough to get them to budge/break free) once the head was off, but I can't get the head off unless I...

Not cafe but kinda funny, have to watch it through to the end. Long, I know... http://www.youtube.com/watch?v=ITHRvEXz2Y0

http://cgi.ebay.com/ebaymotors/Motorcycles___1963-Honda-CB77-Superhawk-CB-CL-305-Cafe-Racer_W0QQitemZ180311631929QQddnZMotorcyclesQQddiZ2283QQcmdZViewItemQQptZUS_motorcycles?hash=item180311631929&_trksid=p4506.c0.m245&_trkparms=72%3A727|65%3A12|39%3A1|240%3A1318

I'm noticing some pics of wheel hubs that are polished amazingly well. Are you guys polishing them with the wheel built or are you disassembling them to polish the hubs? If you're polishing them while they are built, then whats the trick???? ??? Tim

Does anyone have a good source for a gas cap for a '71 CB350 in decent shape? Maybe even a NOS or new replica piece? Thanks Tim

Hi all, I am in the beginning phases of rebuilding my engine and it is apparent that I will need to replace the cylinder head COVER gasket, which is a 3 piece gasket(metal plate sandwiched between two fiber gaskets). I imagine that if I need to I can clean up the metal plate and reuse it but...

Happy Thanksgiving guys and gals! Have a safe and happy holiday! Tim

One of the floats on one of the my cb350 carbs has a small amount of fluid in it. I was thinking of drilling a small hole on the top and on the bottom to allow it to drain, then filling the holes with solder once the inside of the float dries. Any thoughts or experiences? Tim

Hi all, thought I should get around to officially introducing myself. My name is Tim, I live in NW Washington State. Bought my first bike about a month ago, a '71 CB350 for $60. It sat in a field for the last 3 years with the fluids drained, needless the to say it was in a very sad state, engine...

Bought my first bike a few weeks ago, a '71 CB350 for $60. Was sitting in a field for 3 years with all fluids drained. Needless to say the engine is stuck, so a rebuild is in order. Whats the best solvent to use for cleaning the engine parts? I have had great success running seafoam in engines...