Search results

Okay Do the Tonners, I need to replace the rear wheel bearings on a "Comstar" rim, the manual states to use a drift well tried that with NO luck. I've even sprayed on WD40 and let soak overnight still no luck. Is there any tricks, given that they are the originals so have been in there for a...

As the topic says does anyone know the size of the piston? I'm in the process of restoration and my master cylinder is seized and full of gunk so I haven't managed to be able to get the piston out to measure it. Cheers Noz

Just thought I'd share what I've done.. :) I went to my local wreckers and went through what he had and came home with a set of Yamaha FZR 250 (mid 90's ??) rear sets which I think would be the closest to be a direct bolt on. I did have to reposition the mounting point of the gear lever from...

Hey everyone, I'm at that exhaust fitting part of the build and would like to know if the "X" over is needed?? My project is a CB250N. I do recall hearing something about the "X" overs balancing the pressures in the exhaust system but I'm not sure. Could someone please clear it up for me, if...

In May this year I picked up 2 CB 250's 1 x 250N (mine) & 1 x 250T (missus) in basically a 2 for 1 deal that I couldn't refuse. After a carby clean & some fresh fuel both started & idled away. Mine even came with crash bars & panniers 8). Well I stripped mine down & have started the rebuild...

Hey everyone, Just found these links while cruising one of my local forums and thought I'd share.. ;D http://www.aircooledtech.com/tools-on-the-cheap/soda_blaster/ http://www.cyclepsycho.com/crockpot/crockpot.html Cheers NOZ