Search results

Selling my baby to make room for a new project. Link to CL ad. https://charlotte.craigslist.org/mcy/d/1972-honda-cb350-cafe-racer/6613654808.html

Welcome to the group! What part of NC are you living? I'm in Charlotte and also built a cb350 cafe.

I won't know if I have a good coating until I put gas in it tomorrow. Crossing my fingers

Would you recommend that I try it over top of the Caswell that I've already used? I haven't put any gas in the tank yet.

According to their webpage, Red-Kote is for metal tanks only.

j-Rod10: is there a sealant that you would recommend?

I'm in the same predicament. I started with POR-15 with no luck. I got as much of it out as I could and have now gone to Caswell. Just poured it in last night and planning to put gas in it on Friday. Hopefully all goes well. I'll let you know in a couple of weeks. Just FYI: I plan to use...

Looking for headlight switch for a 350. Any chance you have one?

Welcome to Charlotte, Jas. I moved down here from Michigan last year. You'll love it. I'm just north of Charlotte near Lake Norman.

I just found out that my cb350 exhaust will not work with mt set up as it interferes with my rear sets. I would like to purchase a cl350 exhaust instead of trying to make custom headers. Let me know if you have a set of headers and how much to ship to Charlotte, NC. Pics would be nice as well...

I found the thumb latch from a dealer in ohio. I think that it cost me about $20. Call Terry @ Western Hills Honda 513-662-7759 www.westernhillshonda.net

Did you ever get this kick starter issue taken care of? I just got my engine back in and my kick starter hits the brake lever. I did, however, figure out how to get the brake light switch to work. I'll post pics later.

Would this one work? http://cgi.ebay.com/ebaymotors/TRAIL-TECH-NIMH-12V-VEHICLE-MOUNT-BATTERY_W0QQitemZ390169034221QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item5ad7e2fded

I'm thinking that is probably what I'll end up doing. Thanks for the info.

Somewhere on here there was a post about making a cheap sandblaster out of a plastic tube and air spray nozzle. If you don't have an air compressor, I would suggest maybe a wire brush and a few cans of brake cleaner.

It is a '71 engine w/o starter. I was hoping to get one cheaper than that... hopefully someone has one layin around.

I built an SL350 engine but the push rod is toast from a thrown drive chain. The cb and cl clutch push rods are not compatible with the sl engine. Let me know if you have an sl350 clutch push rod and how much with shipping to 49321. Paypal is preferred method of payment. Thanks

Re: CB350 Cafe...The 7 Year Bitch! I have the original rear fender and tail light bracket off my '73 cb350g. They're both in pretty good condition. PM me if you're interested.

Re: The Tortous: cb350 I have a bcr tank and seat combo on my cb350 as well. trying to figure out what to do with the turn signals for both front and back. I'm limited in size on the front right due to the mc being in the way. Was debating doing the single led lights but worried about them...

I plan to use my angle grinder with a 4" disk. I can imagine that a file would take forever. If i was to use a dremel, i would use my carbide grinding bit.