dualero
Been Around the Block
I did not get this right tune,Tune-A-Fish said:Also for you dudes that cant get a race out of the steering head...
Measure to the race top or bottom of head stock right to the base or mating surface of the race where it bottoms out... transfer the measurement outside and dimple about 2mm 1/8" above the mark... then drill with a chisel bit the ones with a smaller drill then flat tip all the way to the race. I then have a second bit the same size with the little bit ground off to finish the hole to the race because the race will destroy the good bit if you just keep pushing.
Once you have the hole just take a hard punch that is slightly smaller than the hole (1/4 - 3/8" i use 3/8) insert it and hit it with a solid blow, the race will break and you should able to remove the pieces. You can plug weld the hole or just fill it with JB after the new race is installed.
you mean to drill through the headstock above the bottom race or vice versa, then punch it out?
Or drilling through the headstock to hit the race directly an then break it?
Thanks
Sent from my GT-I9300 using Tapatalk