jag767
Over 1,000 Posts
Re: The Amalgam: Cb450 frame, cbr500r motor. What could go wrong???
Thanks xb when you compliment someones work i know its meant in earnest.
Hahaha it will come out with the 2 mounts i have done not using plate, but it is not easy! I will try and answer everything.
There is also a mount at the bottom of the case in the rear, all done, just have to box it out with 12ga.
The rake/trail has been gone over, and i will be adding .38 trail with my wheel choice, otherwise good to go.
I dont see why the wheel alignment would be off. But of course i will verify.
If i cradle back under the motor it will be impossible to remove, this is why i planned on just strengthening the rest up a ton.
Thanks xb when you compliment someones work i know its meant in earnest.
Hahaha it will come out with the 2 mounts i have done not using plate, but it is not easy! I will try and answer everything.
There is also a mount at the bottom of the case in the rear, all done, just have to box it out with 12ga.
The rake/trail has been gone over, and i will be adding .38 trail with my wheel choice, otherwise good to go.
I dont see why the wheel alignment would be off. But of course i will verify.
If i cradle back under the motor it will be impossible to remove, this is why i planned on just strengthening the rest up a ton.