Recent content by Nein_Collins

I think the best i've seen is a woman on a sportbike, near the South Carolina border (no helmet law there too) wearing no helmet, a dress with a short skirt and heals... cool to see, but dangerous nonetheless I'll admit though, sometimes riding in a t-shirt is refreshing on a hot day...though...

http://www.z1enterprises.com/Bolt-Set--Honda-CB750-A-7678--Stainless-Steel-Set-194-1247.aspx z1 enterprises....says it's for all sohc cb750's. I've got a kit from them on my cb900, very nice kit, and the stainless socket heads really stand out, esp. on an all black engine.

1981 cx500D more of an acquisition than a purchase, all i've got invested in it right now is 15 bucks in gas to the guy who helped me go get it... won't start on this one til after the cb900 is done though

VERY cool, I'll be following along to see the progress. I'll be picking up my 82 CX500 tomorrow...future project cause I've gotta finish my 900f. Thanks for sharing!

Back when I was in college...went and looked at bikes for the first time.....didn't actually ride one til I bought my first one about 4 or so years ago. Been hooked ever since

Thanks! it's all rattle can!... here's a pic of them on the bike

Niiiiice!

Gaston Motorcycle Shop‎ 4110 South New Hope Road Gastonia, NC 28056 (704) 824-9666 I've been here once, when I bought the Buell and needed to get it inspected, Didn't have much time to look around, be he had a bit of stuff in the yard...was an old man and a younger guy doing repair work. The...

I'm eventually going to do a cartridge emulator and stiffer springs from race tech, right now they are rebuilt with stiffer progressive springs, no air, and 20wt fork oil, I'm planning to raise them back up a little. and I also plan to do the steering damper at some point in the near...

no, not news....I know they are too low...no oil in the forks plus the air hose holes are wide open...drops it down a few inches...It'll be more sorted once it gets closer to riding

it's a roller...now time to wire and rebuild front brakes....then torque everything down and crank 'er up..

wooooord, the way I want to trim it is damn close to what you have here

Re: another dohc honda! project budget cafe CB900F - name to be chosen and now we have an engine...looking like a motorcycle again...and my back hurts..lol

Electrical Designer with a Charlotte engineering firm

Re: another dohc honda! project budget cafe CB900F - name to be chosen update time - Trying to get this thing at least rideable by the Mods V/S Rockers event here in Charlotte the first weekend in June. I've got pretty much all the parts I need other than little bits and pieces and wiring...