Search results

Before I got even close to finishing my last bike, a '74 CB360, I had to sell it in pieces due to life kind of getting away from me. That was about 6 years ago, and I've regretted it ever since. Well a few weeks ago I found another '74 CB360 a few hours from home, and a few hundred bucks and a...

Probably a dumb question, but hopefully someone can set me straight. I'm removing the front pegs from my CB360 and am fabricating some rearsets in the passenger peg location. Does the long stud/rod with which the front pegs are attached support anything else? Is it common practice to just...

Hey all! I just tried to adjust the clutch on my 360, since it was dragging slightly when at a stop, and now I have the proverbial clutch pop. I do have aftermarket cables that the PO installed, brand unknown. I'd like to check the measurements and shorten the sheath if necessary. Does anybody...

Hey guy! Im working on my newly acquired '76 CB360 and its now only running on one cylinder. I had an issue of it bogging down under load between 3 and 5k rpm. I checked float height, cleaned and set my points, and set my timing. After firing it up again I found that it only runs on the left...

Just picked this lil ditty up last weekend. 1976 CB360. The PO couldn't get it to start (which is why it was cheap)... turns out it was just a dead battery! A few hours on the charger, and it started with 2 or 3 kicks. So for I've just set the points/timing, checked valve lash, oil change...

Hello! I've been lurking on here off and on for some time. I found the site when I got my first bike back in High School, a '71 Honda CB450 DOHC twin. I still have that bike but hadn't touched it in years (long story short it was stolen from me, they wrecked it, and I got it back from the scrap...