Search results

Sent from my iPad using Tapatalk

New Project - Board track style V twin 250 Custom girder with MTB suspension unit

A little background first: I've always been a fan of Kawasaki. My first full size motorcycle was a '72 175 F7 and my first street bike was a '74 KZ400. I love the 4 cylinder Z's also for the power they make. The first, and only motorcycle I ever purchased new off of the showroom floor was a 1981...

This is a project monster motor that my father is building. Here are the details: 360 case bored to accept CB500 Twin crank 64.8mm stroke, the 360 case was bored to accept the center main bearings, also clearance for rods and flywheels to swing. Cylinder block sleeved with KZ1100 sleeves with...

Our next project: 1970 CL100 cycle parts, SL125 engine and CB175 front fork, front hub and rear hub. The hubs are being laced to 18 inch Excel aluminum wheels. The collected bits for the build project.

Showing it off... :) My cat hopped up on the bike when I was taking the pics today!

I started (again) on the new chopper this past week. I got the seat post x-member and seat post fish-mouthed and cut, and also mitered the rear wishbones. I'm using the blueprint from the CBH for the CR-200 (Custom Rigid) with wide rear wheel. I'm using a 1.5" backbone instead of the 1.25". I...

Built by my brother Grant Irish, Oakland CA Hand formed Aluminum seat and rear cowl to match tank.

This is the official thread of the 1971 SL350 Motorsport Super Moto Super Motard project by cyclhed