Search results

Hello Im looking for a Honda CG 125 in the UK to start with a quick any easy project for my partner. Thanks

the first try was a disaster ! i ended up scraping the hole seat unit :( i was using expanding foam to make a mold so maybe thats where i went wrong so moving on i will try again with foam blocks and carve the shape out, any tips ?

right... doing to buy the foam this week ! let the seat unit begin !

ahah thats nice but the more i look at it the less i like the whole cowl idea so i might go for the design before that

i was looking more and more at the ducati builds and was thinking about a whole single seat with a cowl covering the back end ?

i will do, thanks guys ! i will get some photos up when i start work

thoughts ? please bare in mind that on this bike you are right over the bars and i have to sit at the very back of my seat to stay stable in fast tight corners just to balance out my weight

i like that thanks but yes i carnt cut the frame at the moment, i will when i have another bike but for know its to much paper work to sort and to long to keep it of the road so i like the shapes that youv made there i might photo something similar, thanks !

thanks for the comments guys and thats a great link ace ! i think i will and get the measurements right for the tail in photo shop and post a pic !

aha thanks for the shot it looks good i was thinking MAYBE something like this ?

i think these lines will make it quite hard to make a seat unit like the one on the ducati

yes i just did and these are the lines from the frame under the seat unit

yes i want a very low profile rear end so that ducati looks perfect and thank you for your comment, do you have any ideas on how to achieve a nice seat unit to match the bike

this is what i was thinking or going for but i really like the single headlight with no fairing but the half fairing does look good. but i think i will fibre glass a seat with a rounded cafe hump on the back and not run any rear seat for example have the seat unit sit flat to the ground so all...

Also thank you for the kind comments and the great ideas. i know i want a round headlamp and there are mounts already there if i dont want to used the forks as mounts and you are correct Dread Rock the sub frame is part of the frame so i was thinking of just a smaller tail piece made from fibre...

here you go HeerD its a picture i found on the internet.

thank you very much and yes i want to change the tail piece but not sure what sort of shape as i run a under seat exhaust but i quite like the idea of making something out of fibre glass and yes the head light is a definite !

Hi guy ! iv been looking over DTT for about a year now and have seen some amazing bikes and have been inspired to do some work on my own bike..... so this is it without fairing, its a 2007 sachs ( German ) xtc 125 and i want to get the look of a cafe, it is my daily commuter in rain and shine...

should always have other transport when doing a project ahah no one wants to take the bus !

looking amazing, can not wait to see it done !