1975 CB750F Cinder Cone (Help Always Welcome!!)

[cbcafejunkie]

Here are the pics:
This is the battery box I made from 22g sheet metal using my vice as a brake. I also reused the starter bracket and welded it to the box. The bare metal place is to act as heat sink for my regulator.

Between my last post and this I must have wired my regulator wrong or damaged it, so I switched back to stock after distorting a battery no more problems.

Here's a cool vintage looking photo of it now

I'm still working these things
*Neutral light comes on only when start button is pressed
*Need correct winker relay for led lights. Anyone know?
* Need to tune carbs was able to start up Thanksgiving but was running rich
My setup as of now ( k&n factory airbox, stock carbs, and mac 4-1 header no exhaust (don't think I'll get a muffler soon unless someone has one that will fit 2 1/2" OD of mac pipes.

 

[spotty]

I'm still working these things

*Need correct winker relay for led lights. Anyone know?

check fleabay for relays, there are 2 or 3 pin ones for very few dollars,

http://www.ebay.com.au/itm/2-PIN-12V-FLASHER-RELAY-FOR-LED-INDICATOR-MOTORCYCLE-MOTORBIKE-BIKE-RESISTOR-/390710146122?pt=AU_Motorcycle_Parts_Accessories&hash=item5af823b44a

http://www.ebay.com.au/itm/Electronic-LED-Blinker-Flasher-Relay-Fix-3-Pin-12V-NEW-/321247538770?pt=AU_Car_Parts_Accessories&hash=item4acbd86e52

at that price, it can't hurt to try, if they don't work you may need to use the 'ballast' resistors

http://www.ebay.com.au/itm/50W-60ohms-LED-Turn-Signal-Lights-Blinker-Flasher-Load-Resistors-Fix-7443-7440-/140886592056?pt=AU_Car_Parts_Accessories&hash=item20cd7eca38
a bit of searching will find sets of 4 at lower prices than this - you need one per indicator

i've used both fixes (my yamaha has its flasher relay combined with something else so i couldn't just replace it, had to use the resistors) and they work just fine

 

[cbcafejunkie]

check fleabay for relays, there are 2 or 3 pin ones for very few dollars,

http://www.ebay.com.au/itm/2-PIN-12V-FLASHER-RELAY-FOR-LED-INDICATOR-MOTORCYCLE-MOTORBIKE-BIKE-RESISTOR-/390710146122?pt=AU_Motorcycle_Parts_Accessories&hash=item5af823b44a

http://www.ebay.com.au/itm/Electronic-LED-Blinker-Flasher-Relay-Fix-3-Pin-12V-NEW-/321247538770?pt=AU_Car_Parts_Accessories&hash=item4acbd86e52

at that price, it can't hurt to try, if they don't work you may need to use the 'ballast' resistors

http://www.ebay.com.au/itm/50W-60ohms-LED-Turn-Signal-Lights-Blinker-Flasher-Load-Resistors-Fix-7443-7440-/140886592056?pt=AU_Car_Parts_Accessories&hash=item20cd7eca38
a bit of searching will find sets of 4 at lower prices than this - you need one per indicator

i've used both fixes (my yamaha has its flasher relay combined with something else so i couldn't just replace it, had to use the resistors) and they work just fine

Thanks a ton. I was trying to use an ep35 flasher relay from autozone, however it wasn't working quite right.