CB360- 379 Conversion, Pistons, Jugs, Head, Lets make a deal

[IanOberholtzer]

Ok... so heres the deal id like to make,


i have


4 gs850 pistons with rings & pins
2 cb360 jugs
2 heads


but I only need one motor


soo.....


I want to get them all bored, a bit milled off the top to raise the compression .020 of an inch to be specific, and have a 3 angle job done on both heads, and cut costs.


If you pay for the machining (250 - 300 ish), or otherwise can make the machining happen I'll mail you your set as soon as they are ready ( two weeks? )


Im located in central florida / orlando area, and have lots of feedback and references if needed.


Ian-

 

[Sonreir]

Re: CB360- 378 Conversion, Pistons, Jugs, Head, Lets make a deal

Technically, it's a 379, not 378.

Either way though, that's a great deal. My pistons + rings and machining cost me about $600 for the same conversion.

 

[IanOberholtzer]

Re: CB360- 378 Conversion, Pistons, Jugs, Head, Lets make a deal

Technically, it's a 379, not 378.

Either way though, that's a great deal. My pistons + rings and machining cost me about $600 for the same conversion.

ahhh my friend, duly noted