IanOberholtzer
green behind the ears
Ok... so heres the deal id like to make,
i have
4 gs850 pistons with rings & pins
2 cb360 jugs
2 heads
but I only need one motor
soo.....
I want to get them all bored, a bit milled off the top to raise the compression .020 of an inch to be specific, and have a 3 angle job done on both heads, and cut costs.
If you pay for the machining (250 - 300 ish), or otherwise can make the machining happen I'll mail you your set as soon as they are ready ( two weeks? )
Im located in central florida / orlando area, and have lots of feedback and references if needed.
Ian-
i have
4 gs850 pistons with rings & pins
2 cb360 jugs
2 heads
but I only need one motor
soo.....
I want to get them all bored, a bit milled off the top to raise the compression .020 of an inch to be specific, and have a 3 angle job done on both heads, and cut costs.
If you pay for the machining (250 - 300 ish), or otherwise can make the machining happen I'll mail you your set as soon as they are ready ( two weeks? )
Im located in central florida / orlando area, and have lots of feedback and references if needed.
Ian-