cb360 rear brake spring installation?

atx360

New Member
Cant quite figure out how this spring and adjusment screw at the brake pedal all jive??

Any help would be appreciated. also this is a 75 cb360 and mounting a cl360 pedal........thanks for the help gents. ;)
 

akretz360t

New Member
It's kinda tricky to get on, the spring that is. I usually install, make sure the little bend it propped behind the metal stopper on the frame, and then use pliers to pull the part of the spring "the L you could say" that sits behind the brake pedal around to add tension/spring. From there you use the adjuster spring that pushes against the brake pedal to set the height, too high and it will rub against the cover.

Keep in mind, if you look at a fiche page it makes it look like the spring goes on the outside of the brake pedal, however it actually sits in the inside, closer to the swing arm.

It just takes some sitting and looking at it to figure it out, trust me I was in the same boat as you. I had not seen it installed b4....
 

Sonreir

Oregon
DTT SUPPORTER
I could be wrong, but I think the CL pedal isn't compatible with the CB brake cam. I had a ton of hassle converting my CJ pedal to a CB. Big differences in the frame and the pedals.
 

atx360

New Member
Sonreir said:
I could be wrong, but I think the CL pedal isn't compatible with the CB brake cam. I had a ton of hassle converting my CJ pedal to a CB. Big differences in the frame and the pedals.
I ordered the whole deal....cam and rod and spring and pedal. but I cant get the spring to return the pedal?
or is this cam and all not compatible with my cb frame???? :'(
 

atx360

New Member
Bump......I still can't figure out how to get the Cl pedal on my CB frame. If I have to chop and weld that's fine I just want someone to shine some light thanks.....

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2
 

andoor

Member
I got the CL spring to work on my CB. I had to place it kind of funny. I wasn't sure if the way I have it would hold up, but it has been ok for over 1000miles. Hard to explain, I will take a picture an post it when I get back home.
 

atx360

New Member
Re: Re: cb360 rear brake spring installation?

andoor said:
I got the CL spring to work on my CB. I had to place it kind of funny. I wasn't sure if the way I have it would hold up, but it has been ok for over 1000miles. Hard to explain, I will take a picture an post it when I get back home.
Thanks man a pic would help me lots.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2
 

atx360

New Member
OK so that helped I have the spring installed but how do you lock the peadal down so that it doesn't activate the brakes ob the upswing?

I hope that explains it well enough.

Thanks for the help

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2
 

atx360

New Member
Nevermind, I just got it figured out. I had the brake Cam upside down.

Thanks again for your help

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2
 

DTT Bike Of The Month Gallery

DTT Light or Dark

japan.webike.net
www.cognitomoto.com
https://www.townmoto.com
www.speedmotoco.com
www.jadusmotorcycleparts.com
www.lostapostle.ca/
www.sparckmoto.com
Top Bottom