1978 CX500 Build

Sounds like I need: a 500 output shaft, modified 500 front motor mount, 650 wiring harness. Anything else you know of that I need for the 650 swap?

I'd like to get up your way while I'm in SC later this month but I'm not sure if the 4 hour round trip is going to fit in the schedule. I've got your phone #. Texting okay? Texting is easier for me since I'm either at work or in a house full of small kids.
 
650 rad and rad hoses rad will need some mods

650 controls and igniters/12v coils and regulator with a 650 key switch or you can use all the gl 500 wiring stuff

unless you want to do some custom stuff

you will need either new soft stretchy 500 intakes then re jet 500 carbs and it will sort of run

or everyone that does the 650 swap uses my carb kit to do it right and get some hp out of it

650 carbs will not fit the center spine cx500 frame
 
http://cx500forum.com/forum/cx-customization-modifications/14289-first-impression-murray-s-carbs.html

and i sent you a pm
 
Hey Murray,
While I'm thinking about it I have a gl400 motor that I don't plan on using as I'm upgrading to a 500.
If you still want/need one to tweak your carb setup for Asian markets that got the 400, let me know.
I'm over near Chapel Hill...
 
Back
Top Bottom