I gave the bike a few more kicks after work today and didn't get anywhere. I'll give you guys a rundown of what I know so far -
- It took me a while to get the cam timing right, but I'm pretty sure it's spot on. I went through the trouble of ordering a second cam chain because I didn't like the first one. I posted pics previously in this thread - See reply #44, not #40.
- New universal coils mounted in the stock coil mount location. The frame was powder coated, so I ran a seperate ground wire from the new coil mount I fab'd back to the frame ground below the carbs. Continuity was checked and good from the coil mount to the battery
- New battery, charged.
- I followed the static timing procedure posted on Honda Twins to set my static ignition timing. I set the proper gap on each point, then With my test light connected to the yellow coil lead (coil connected to my LEFT cyl spark plug), I set the point plate such that the test light lit just when the mag "LF" mark reached the pointer. Then, with the test light connected to the blue lead (coil connected to my RIGHT cyl spark plug), I set the point gap such that the test light lit just when the mag mark "F" reached the timing mark.
- Carbs were soaked and cleaned. Rebuilt with a rebuild kit that included new jet (stock sizes). I believe my right cyl float level needs to be adjusted. I'm running clear inline fuel filters and the right cyl filter is dry after sitting for 5 days.
- I checked the compression tonight with a known good gauge - 120psi in both cylinders after numerous kicks with the throttle open. I'm disappointed in the 120psi - I had 150psi before I tore this engine down. I reused the pistons and installed new rings. I'm hoping that after I run this and the rings get a chance to seat, the compression number will come up. Regardless, 120psi is enough to run
I can't work on the bike until Sunday. I plan to first check my static initial timing again to make sure the points plate did not rotate. I know that things can be installed 180deg off, but can it still seem to be timed "properly?"
As always, I appreciate any help or suggestions. I'm pretty excited to get this thing running so I can start fine tuning things.