Make sure you have your vision/end result hammered out before you powder. There's a couple things I need to grind off along my seat rails (hinges, seat lock) and something I wish I added (rear set mounts, fender bracket). Since I rushed to powder coat it I will have to "touch up" with some semi-gloss spray paint. Not the end of the world but proper planning would have been better...but hey, it's my first build!Doc. said:Also, these are the parts I have decided to powder coat. If there is anything I missed, or you guys recommend I also do while I'm at it, please feel free to share. I want to make sure I get all the right parts powder coated now, than kick myself in the behind later.
clutch said:Make sure you have your vision/end result hammered out before you powder. There's a couple things I need to grind off along my seat rails (hinges, seat lock) and something I wish I added (rear set mounts, fender bracket). Since I rushed to powder coat it I will have to "touch up" with some semi-gloss spray paint. Not the end of the world but proper planning would have been better...but hey, it's my first build!
Yea it looks like that will work perfect, I will definalty do that, unless my dad has some werid gizmo that I dont know about. Good luck with the rearDoc. said:Thank you!
I used this method
http://www.dotheton.com/forum/index.php?topic=9448.msg83326#msg83326
It was a little pain in the butt because the anchor was a bit smaller than it should've been. If you get one with a diameter close to the bearing hole, it should work well. I still haven't pulled out the rear hub bearings because it's bigger than the front, so I'm going to get a bigger one tomorrow to do that. Hopefully it'll go much smoother, lol.
Thanks. Give it a shot, it's not much so no loss in that.1976cb356 said:Yea it looks like that will work perfect, I will definalty do that, unless my dad has some werid gizmo that I dont know about. Good luck with the rear