cafe mike said:So you tried to get spark? Or or you just measuring stuff
cafe mike said:Pull the coil wires out and measure just the wires
cafe mike said:Cut off the damaged part of wire and try again, don't go bat shit crazy tighten the down and make a mark on wire so you know when your down in cap
Still no spark. Have you ever had the ei to spark for you? And your old coil was bad when you checked it?1sttimer said:Ok so I measured from the coil end of the wire, through the wire, through the cap and got about 5 k-ohm through each. I know the cap is screwed in right now.
When I plug the connectors into the coil, I get zero when measured through the caps. If I remove the plugs and read through the coil I get 17 or so.
Are you measuring the coil with power leads disconnected?1sttimer said:Ok so I measured from the coil end of the wire, through the wire, through the cap and got about 5 k-ohm through each. I know the cap is screwed in right now.
When I plug the connectors into the coil, I get zero when measured through the caps. If I remove the plugs and read through the coil I get 17 or so.
cafe mike said:Are you measuring the coil with power leads disconnected?
1sttimer said:No...I guess I should do that. Good point. That still doesn't explain the lack of spark though right?
I get 25.01 k ohm when I insert meter leads into caps with power wires still connected1sttimer said:No...I guess I should do that. Good point. That still doesn't explain the lack of spark though right?
cafe mike said:I get 25.01 k ohm when I insert meter leads into caps with power wires still connected
Make sure you run the wire into the coil all the way before slipping your boot around coil insulated post, I think your not going in far enough to make continuitycafe mike said:Are you measuring the coil with power leads disconnected?