Or the wrong Popsicle... Haggondoz sticks are huge1sttimer said:I'd be the one with the Popsicle stick in the wrong way![]()
Or the wrong Popsicle... Haggondoz sticks are huge1sttimer said:I'd be the one with the Popsicle stick in the wrong way![]()
Texasstar said:I want to try one of these![]()
Weber Carburetor Syncrometer SK Type 1-30 kg/hSonreir said:I don't know what it is, but I want to try it too.
Texasstar said:We plan on making a skid to test our motor out of the bike
Sent from my iPhone using Tapatalk
cafe mike said:I can bless you guys with mine... Just need a flat surface to mount to..
Pm your address and I will send it out (don't worry I get huge discount to ship)
Thanks .... And I found that missing washer just now. Lol1sttimer said:Woah that thing is sweet.
thanks Mike what I meant to say was we are going to test it on our skid before we install in our bike. We have one just need to hook up some controls and a kill switchcafe mike said:I can bless you guys with mine... Just need a flat surface to mount to..
Pm your address and I will send it out (don't worry I get huge discount to ship)
xb33bsa said:use 2 (one in each carb)excactly same size,MEASURE THEM WITH CALIPERS !, popsicle sticks on EDGE inserted gently so that they hold up the slides
they needs to be fully under the slide not just at the cutaway
use a light and look in make sure the are evenly seated on both sides basically they will be propped up by the needle and the bottom edge of stick flat to the floor of the throat of carb
now when you very slowly open the throttle the sticks should be released from the slides EVENLY at the same time the sticks are being used like a feeler guage kinda
just use one or the other cable adjusters at the top of carb to get this right
Your not going to get "it" under needle1sttimer said:XB how about this video? You approve? Judging from the angle of the stick it looks like he may just have it under the cutaway, not the needle too?
http://m.youtube.com/watch?v=Dgh91t7JnNY
xb33bsa said:goddamit,1rst timer, how hard fucking hard can it be to follow instructions are mine tjat fucking un clear!!!!!!!!!!!
cafe mike said:Your not going to get "it" under needle
Sometime you need to read between the lines. You know enough about what's to be expected by now. I want you to stop finger banging the keyboard and get it running. Enough with the high beam relay. Just start that thing up1sttimer said:Well I didn't think so but it seemed like his directions explicitly said to not have it just under the cutaway.
xb33bsa said:you need to have it slid through the carb ON EDGE so that it contacts the front edge of the slide,not the cutaway
when you move the slide upwards from there it will be more or less still vertical because it will be proped up leaning against the needle
you cannot ever get it under the needle anyway, the needle never comes that high :![]()