I received my bars and seat the other day so it inspired me to do a little more work on the bike. I decided to cut a few more tabs and other things off. I'd love to weigh what I've cut off because the bike feels a lot lighter. However, it might just be wishfull thinking. Here is a rear profile. I'm really starting to fall in love with these little bikes. I think the skinny tire on the back just rocks. Nothing is bolted down yet and I just wanted to get an idea where things will go.
I think I'm going to weld the bar back on the back. I don't like the look with the frame just cut off. It looks unfinished that way.
I also decided to go with a speedometer instead of the tach. Right before Christmas my family and I took a trip to Pittsburgh to watch a concert. Anyway, during the trip it made me realize that knowing my exact speed might be important. You know, Do I just pull over and take the ticket or I was going fast enough that I better just keep going and not stop?? ;D
here is a photo of the speedometer. With just one support it looks like it kinda floats (might vibrate like hell though)
Another photo of bars and speedometer. The bars are from Champ. I think it's a pretty good deal for $75.00 shipped. the chrome is easily scratched but I figure what the heck. They feel like they should be plenty strong enough.
Tank sucks with this seat. I think this is about where the seat will go once I get a new tank. I left some of the side covers tabs on for reference point.
There are lots of things out of place. By the look of these photos the bars are too straight and need to be adjusted back some. The headlight is held on with zip ties and all the wiring is help up with zip ties as well. I don't plan to relocate any wiring, battery holder or weld seat brackets until I get a tank. Once I get the tank I plan to use the factory seat hinge on the front of the new seat. I think I can cut it down and bolt it on the front so the seat can flip up from the rear. The the real work will begin.