wozza said:Yeah..
Do you remember where, in case you found a very good offer
wozza said:Yeah..
CrabsAndCylinders said:Some people don't recommend soldering connections on bikes because the connection will not flex and some wires, such as where they pass around the forks, need to flex. If you do this on a section where there is no wire movement then I think it should be ok.
pidjones said:Honda petcock has no o-ring for the handle, either. Just a nylon washer for the wave washer to run on. I just rebuilt the original on my '79 GL1000 with an All Balls kit. Drilled off the rivets, drilled holes for screws, cleaned it well inside, put in new seal, lubed it with a little silicone grease, installed new wave washer and nylon washer on the operator, put on the top plate and screwed it down with the self-tapping 4-40 screws. Silicone on the new sealing rings (this petcock seals to a flat flange on the tank with two holes for the normal/reserve tubes), and screw it back on.
Yes, I have a Motogadget Mini embedded in the headlightSo you're going to drive that with the cable from the wheel and send the signal to an aftermarket speedo?