Recent content by Si123

Does anybody know of a descent place to store a bike near midtown in Omaha, NE?

That look like them. Maybe they are a little bigger then a 1/16th closer to an 1/8th. I wonder if I can pull that off and re-grease it?

I took off the cover to expose the bolt to rotate the motor counter clockwise and found 1 medium size ball bearing I would say about 1/16 of inch in diameter. Where could of this came from? I went ahead and started it and it runs like a champ. Should I be scared to ride.

Will you sell just the diaphragms

Carb diaphragms

It aligns with the slot on the right hand side of the pic

You know that small brass bar that only lets you insert the needle jet a certain way. You have to line up the grooves of the needle jet with it. Mine fell out and I can't find it any where. I've been googling diagrams looking for a part number for a while now. Does anybody know a good way to fix...

Okay there was no water or sediment in the carbs, but I figured out whats wrong. You know the little brass insert that only lets you insert the needle jet a certain way? It fell out. I can't find it anywhere. I've looked online and i cant find a replacement.

Thanks I'll pull it off tonight and clean it. I need to get this thing dialed before gas prices spike anymore

I have an old cb360 I bought for a couple hundred buck and slapped a pair of mikuni 32 VM carbs on it. I later figured out they were way too big, but I re jetted them, and had it running pretty good for awhile. When I first put the carbs on I couldn't get it to run off the left cylinder, I ended...

I need one diaphragm.

I bought for my cb360 I think they are too big. Let me know what you have or make me an offer have rejetted to a 30 pilot and 150 main. Would come with 35 pilots and 190 mains too.

I have it running somewhat okay now, but yeah I should probably look into that. What kind of mods would you suggest doing?

I have a 74 cb360 (bone stock 14500 miles) that I've been tinkering with. I pulled a noob mistake and bought to big of mikunis for her (32vm) I could really use some jet and needle suggestions???? I'm from Springfield mo.

I have a 1983 Suzuki rm250 that is somewhat tore up. I thought about trying to find a bike with a clean title to swap the motor into. Any thoughts?