Search results

Well, due to me not only leaving my job, but moving back to Texas, I am forced to sell my bike. I am really just getting an idea of how much I should ask for it, but any serious offers will be considered. First, here is a pic: and here is the link to the build...

So I have some running issues. It starts, but won't stay running. I do have issues getting it started, too, but not as severe. After 5-8 kicks, it will begin to fire and eventually start up. Then I have to rev it a bit to keep it going which produces some white smoke. It idles at about...

So the original bleeder in my caliper was so siezed that I ended up just drilling it out and retapping the hole. I purchased a 7mm by 1.0 inch speed bleeder, marked the hole location on top w/a sharpie, and inserted it. I reassembled the brakes and got the fluid pumping with the help of some...

So I wasn't sure where to post this, but anything goes, right? I was curious how you ladies and gentlemen see your own bikes. I post this topic because I see other member's bikes and think they are fantastic. I won't drop names, but there are some remarkable machines on here. I see no flaws...

So I've got a smaller battery setup on my 360. A 12 volt, 4 amp model. I know quite a few guys on here are running smaller ones. I haven't gone on any long rides, so I was wondering how long a fully charged battery would last constantly powering the lights. 4 hours+?

I having an issue with the front disc brakes on my CB360. Simply put: I can't get the brake fluid flowing. The brakes were completely disassembled. Nothing remained connected and all the pieces got a good cleaning. I also purchased a supposedly functioning BMC and lever from an 82 Magna V45...

my bike won't fire. i eliminated the starter, so i am only on kick. took the bike completely apart six months ago and it would start on the first kick. fast forward to today. finally all assembled, i go to start it and nothing. check petcock, choke, ignition and everything if perhaps i...

I have a sealed battery and am having some fitment issues. I know one can mount a sealed battery on it's side, terminals facing horizontal not vertical, but are there any issues that a side mounted battery might have? Shorter life span, leakage? Anyone have theirs mounted on it's side? Any...

I know there was a thread a while back, but I can't seem to find it. You guys have any tips for running the wires through those pesky, not-quite-big-enough holes on handlebars? WD40? Crisco? Hella patience?

Soooo I went to pick up my Roadriders today from a local mega motorcycle/dirt bike/four wheeler place, snatched them up and headed over to the service dept to have my wheels relaced, trued, tires mounted and balanced, etc. After inquiring how much $$$ to do so, the guy looked at me funny...

so i'm looking for fork gaitors for my cb360. i know i need a small/upper opening of about 1.5" and a large/lower opening of 2.25". two part question: will gaitors from a cb350 fit? if not, which ones will?

There are so many 360s on this site, figured I'd have fun with the topic name on mine. I considered CB360 Degrees, but that seemed to easy. Here she is the day I got her, and yes, that is my kitchen. I live in a duplex w/no garage, so all the pics will be the kitchen, basement, or dining...

so i can't for the life of me figure out how to remove the front axle from the wheel of my cb360. i consulted the Clymer, but there is nothing in it about removing the axles.

I need some advice from the gurus, so here goes... I need new tires for my 74 cb360 using the stock wheels. It is actually a 3 part question. 1. I have heard mixed things about using tubes w/tubeless tires, but that it generally isn't bad. It just allows the TL tires to seal on the old...

Name's Casey. Texas born and raised, and proud of it(i've got the tattoo). Longtime reader, yadda, yadda, etc. Moved to Vancouver, Washington in January(for a woman, of course, but that's a different story) and after being here a week I bought a 1974 Honda CB360 barn gem for $950. 4500...