There are mate, but you're gonna have to dig thru the thread to find them. Made the pan from steel (I think, might have been aluminium), but had it professionally upholstered. I'll see if I have any photos of the underside - to be honest can't remember if it was glued or riveted.
Haha well that’s certainly one way to put it I guess. Spent plenty of time on it, at least all the time it needed anyway. Nope, not the same tank. Guess I’m not your guy
Sent from my iPhone using DO THE TON
I riveted a tongue to the front of the pan to secure it, and - once the seat had been upholstered - installed 2 rivnuts at the back so I could bolt into the pan through the flatbar support across the hoop.
Use a layer of rhe floor mat puzzle foam cut and fit all around that frame and you should be fine.
Yup, that thing is built to last for sure. And the bends in that pan look great mate, nicely done.
I hope you don't end up feeling that substantial frame when you're an hour in the saddle?
Maybe a few beads rolled into the 18gauge would've stiffened it up enough? It worked on my 3mm alluminium seat pan I knocked up.
No issue...I'm lucky, my mate has a bead roller which is handyDefinitely. I just did not have a way to do that or know anyone locally that does.