Dreadnotred Hellride chopper

[irk miller]

Front caliper sorted with a Tokico that came off an EX650. The 750f fork mounts were within an inch from the caliper mounts, so it just required a small bracket to move the bottom hole, while still using the top hole. Then two spacers were machined to match the offset.




Sent from my iPhone using DO THE TON

 

[irk miller]

Back brake done.




Sent from my iPhone using DO THE TON

 

[irk miller]

I had a blast with the wire wheel digging through all the bondo on a smoothed out 70s chopper frame in all the usual spots, only to find no numbers. Looks like we’ll do it by the engine number...




Sent from my iPhone using DO THE TON

 

[Maritime]

Can you stamp the engine# on the frame too and have "Matching Numbers"?

 

[irk miller]

Can you stamp the engine# on the frame too and have "Matching Numbers"?

That's what I'm thinking I'll do.

 

[Maritime]

That's what I'm thinking I'll do.

That will make it more appealing at Mid-O for sure, for all those who think that's important LOL.

 

[pidjones]

Except that I've never seen a "matching numbers" Honda.

 

[irk miller]

Except that I've never seen a "matching numbers" Honda.

It's not a Honda.

 

[cxman]

Except that I've never seen a "matching numbers" Honda.

they are around but few and far

 

[irk miller]

I changed my mind and decided to run a dimpled tank. Anything in front of the down tubes runs the likelihood of interfering with carbs/air filters.


Sent from my iPhone using DO THE TON

 

[Maritime]

That looks good.

 

[trek97]

Except that I've never seen a "matching numbers" Honda.

If I recall my CB360 engine and frame #s match. Currently stored in my neighbors garage so I can't look at the moment.

 

[canyoncarver]

New oilbag looks right to me.

 

[cxman]

i like that

 

[irk miller]

i like that

Plenty of room for your carbs

 

[Hurco550]

Currently stored in my neighbors garage so I can't look at the moment.

I wish I had a neighbor that let me store stuff in his garage.

 

[cxman]

Plenty of room for your carbs

yup and they will install to the inside

 

[irk miller]

As it is.


Sent from my iPhone using DO THE TON

 

[JustinLonghorn]

Yep. I dig the stance for sure.

 

[trek97]

Lookin good my man.