biker for life
Active Member
Hi, i would like a second opinion for the problem i just discovered. i followed the steps described in the first post. After sandblasting the tank to bare metal i only had to do a small spot with body filler. Sanded it all down to make it nice and smooth again. Washed and prepped it all following the guidelines and applied several coats of primer. So far so good. The touched up spot was not visible after primer.
About a week later i applied the first 12 coats of white paint and this morning a see that with the light at the good angle, the spot is visible again...
What to do now? Will this go away again after covering with another 12 coats?
Or do i have to sand it all down again and start over...
Verstuurd vanaf mijn GT-I8190 met Tapatalk
About a week later i applied the first 12 coats of white paint and this morning a see that with the light at the good angle, the spot is visible again...
What to do now? Will this go away again after covering with another 12 coats?
Or do i have to sand it all down again and start over...
Verstuurd vanaf mijn GT-I8190 met Tapatalk