yes it issimo said:After almost 100 pages & how many hours ... I'd hope that lucky was a tad ahead of stock. Nice to have your own 1/4 mile.
it has ethanol in it???Sonreir said:Forgot to ask... you're running non-ethanol gas, right?
we are gonna try some c-12 once we get back from barber and drill the floats out to 2mm...have you tried any of these fuels http://www.vpracingfuels.com/motoroadracing.html?Sonreir said:Most gas does, yeah (at least here in OR). You can get pure gas (non-ethanol) at a few places.
www.pure-gas.org
will do. Sonreir have you researched ceramic wheel bearings?Sonreir said:I have not. It would be interesting to see if they live up to their claims. I bet someone with some dyno time could figure it out.![]()
If I was given that advice when I was 13...researching everything about tires /wheels at the moment. When I was 13 this kid showed up at the BMX race with bigger wheels,Sonreir said:An obvious improvement, but I'd be hesitant to chalk it up just to bearing materials without further investigation. I suspect there could be more at play.
not without the fairing. No problem in 4th gear...don't have enough road for 5th gear...yetSonreir said:19" wheels gains you a theoretical 5mph on the top end, but does your bike have the power to push it? Are you currently able to hit redline in top gear?
Texasstar said:Will going down to 17's help with that 5th gear by reducing the mass?
we are running a 17/35 at the moment...4th hits 80 no problem...16/35 gets its to 75 in 4th and then the dog of 5th.Sonreir said:Going to fewer teeth on the rear sprocket and/or more teeth on the front sprocket will help, too.
If you can find the .96 fifth gear, swap over to a 19" wheel, and go with a 15/35 front/rear sprocket ratio, I put you at 101 mph in 5th gear at 10,000 RPM.
Texasstar said:we are running a 17/35 at the moment...4th hits 80 no problem...16/35 gets its to 75 in 4th and then the dog of 5th.