Texasstar said:And why didn't we get a voltage reading when it was connected to the negative terminal on the coil
1sttimer said:Good questions, and why do I have continuity now?
on his continuity test...if his power was on to the negative side I understand how it wouldn't work but if his power was off why didn't the continuity test work through the resistor caps?Sonreir said:Hard to say without looking at it in person, but I will weigh in on a few points made over the last few pages:
1.) While it technically matters which side of the coil is positive and negative, in practice it doesn't. You can hook it up either way and it will work.
2.) White wire is definitely the power wire. Not yellow.
3.) If everything is turned on and you check for power on the negative side of the coil, you'll (probably) only get a reading if the yellow is unplugged. If everything is left plugged in, the power will flow through the yellow wire to ground and bypass your test light.
Sonreir said:I'd need some more details of how the test was performed.
Resistance through plugs, caps, and wires can sometimes exceed 25,000 Ohms (depending on setup). Unless a multimeter is used (and in the correct setting), you can get a false negative.
Sonreir said:Were you just using the continuity setting or reading resistance using the Ohmmeter?
we addressed thatSonreir said:10:1 odds says the meter wasn't set to read a high enough resistance level. Switch it over to the 20KΩ and see what you get.
Sonreir said:10:1 odds says the meter wasn't set to read a high enough resistance level. Switch it over to the 20KΩ and see what you get.
Sonreir said:And which two points were being used to measure the continuity?
Texasstar said:I just realized why fluke voltage ohm meters are called fluke
Sent from my iPhone using Tapatalk
Sonreir said:And how about when to measure between the end of the plug wire and ground?