acm177 said:And if you ever decide to redo your 175's transmission, the 200 has solid locating pins in the transmission.
I too had a cl200 that I bought for parts... I bought it of some yinzer that painted it teal, ugg. I cant think of any other 200 parts i used in my 175.
xb33bsa said:you will probably want a new drain plug anyway so a carefully placed cold chisel will do the trick to break it loose or just weld a bar to it or a large cheap throw away 1/2 drive socket welded to it
in fact a socket welded to it could be a permenant solution
acm177 said:Yeah I have that cl200 that I rebuilt with 1mm over pistons and decked for a bluprinted stock engine 208cc?. It just sits in the corner as of right now.
Now that i think of it, the main reason i bought it was for the cam, which I sent to megacycle and put in my 175. Since the 200 cam has bolt holes the 175 sprocket was machined to fit and slotted for adjust ability.
Really just a money sink. I had to buy another 200 cam and oil pump but I swapped the locating pins and stator from the 175.
It's got the oem 175 carbs bolted on but ive never fired it up
xb33bsa said:if you weld something on it remove it while still hot, but DO let the heat soak into the al
acm177 said:Nah... The 175 is the one with the power! Short stroke, cam, high compression pistons (198cc), lightened clutch, high perf valetrain and oversized valves!
Just to brag a bit.
acm177 said:Arias pistons, via Mike Riddle.
What I would like to know is how Mike's 175 bike won all three classes at Willow Springs...with Billy Hamill aboard?teazer said:How do Mike's pistons work in a 175 head? They look to be very tall so I imagine that it takes a lot of spark advance to work well.
teazer said:How do Mike's pistons work in a 175 head? They look to be very tall so I imagine that it takes a lot of spark advance to work well.
What about the idle screws. We talked about backing out till they bottom out. The cable adjustment could be keeping it up a bit1sttimer said:Speaking of idle, can you guys walk me through the procedure for dropping a high idle?
I'm idling around 3k now. Bike runs strong and has solid throttle response in all gears at all revs...just never drops.
I am at stock 175 jetting, air screw 1.5 out and mixture screw 4 turns out from bottom. I tried the procedure in the manual to back out the air screw until highest idle is achieved then adjusting the mixture screw to bring revs back down...the revs I can get down but the throttle won't respond and it eventually bogs if I don't keep the throttle cracked.
Also, it sounds like I'm pulling more air in via the right carb (just makes a lot more sucking noise) even though the carbs are set at the same screw positions...and synced with Popsicle sticks.
Idle is done throughout the pilot, air screw, idle screws and timing. Your timing is good, your stock pilot is fine.cafe mike said:What about the idle screws. We talked about backing out till they bottom out. The cable adjustment could be keeping it up a bit
cafe mike said:What about the idle screws. We talked about backing out till they bottom out. The cable adjustment could be keeping it up a bit
cafe mike said:Idle is done throughout the pilot, air screw, idle screws and timing. Your timing is good, your stock pilot is fine.
You and me need to throw our bikes on the dyno and have tuned