Recent content by marcus91

I'm looking for the following parts. - Taillight (only the glass) - Shifter-pedal - Headlight ears - Brake-level - Tank (if cheap) - Seat (if cheap) - Fork legs (if cheap) Seller must ship overseas. I will pay shipping.

Thanks for the reply. :) I found this, and it helped a lot: http://www.youtube.com/watch?v=i8mnmH59Azc But I managed to burn up the Boyer ignition unit... So I'm kinda bummed about that right now. How is it if I chose to run the bike without the ignition unit? And what wires must go to the coil?

Need some help with the wiring on my 72' XS650. I'm wondering which of the wires from the alternator goes to which of the wires from the regulator/rectifier. Also I'm using a Dyna coil. On the left-side of the coil i hooked up the red wire (power) Boyer ignitor unit and on the right-side i...

Do you have airbox for 80' CB750K? Price?

Need to buy some cheap parts for my CB750 DOHC. - Gas tank (including petcock, gas-cap etc.) - Airfilter-box

The bike is from 1980. The stock wiring diagram can be seen here: http://5united.org/articles/wiring/79rs.jpg Hope that gives you the info you need :)

Anybody got a simplified wiring diagram for an airhead?

The bike is actually completly stock.

My CB550 is acting weird. - Wont rev past 6000-7000RPM (sputters/stalls) - Dies when I give full throttle - Reacts fine on the throttle with choke ON - Spark-plugs are dry-fouled Air/Mixture problem??

I have a 75' XS 650 Bobber. Currently the bike is running a 12V-3Ah battery (kick-start only), but I'm getting sick and tired of kicking at least 20 times before the bike starts so I want to hook up a 12V-14Ah battery to the system. Can I just connect a wire from the starter and another wire...

Alright.. I think you pretty much did for me:p Rebound spacers it is!

How will the riding be if I run the bike 2-3 inches lower in the front (I will cut the springs) without running a rebound spacer?

I live in norway, so I don't have luxury you guys have to pay low amounts for welding and sandblasting jobs. Just to show you an example, say I want to sandblast two rims for my CB350. That job would easily cost right around 300$. An OK compressor cost in the area of 200$ and a welding machine...

Thanks for the help guys! I will buy a compressor and a sandblasting-kit soon and get started on the project. Also I have another question. I'm actually in the process of making a brat-bike. The making of the seat-pan isn't really an issue, but I'm quite new to the process of adding a...

I want to strip the paint off the gas tank on my CB 350 and just go for the "bare metal look". Can I just sandblast the whole tank? Im kind of afraid that the sandblasting will leave holes and cracks on the tank though. Will this be an issue?