Search results

I have an old leftover project that's been sitting in my parents house and they want it gone. I live in NYC now and cant take it on. Is this useful to someone here? Its basically everything from a 72 CB350t minus the frame, plus some extra parts. List includes: CB350 motor, with electronic...

Ok, so I’m making this thread in an act of desperation. I have a cl350 I’ve done a lot of work on trying to get it to work right, but still somethings up. The problem: I can start the bike ok with no choke (sometimes needs the slightest bit of throttle) and go ride for a few minutes (all good)...

I'm going to clean out my garage this week to try get some money towards a new welder. I will keep updating this thread I'm located in westchester, NY 10549 Other things I have: CB350 swingarm, red side covers, 33mm chrome clipons, cb350 speedo (if youre interested in any Ill take some pics...

Quick question, I'm about to try to start my bike and have always had this question. After pulling the carbs and reinstaling them on the bike (float bowls empty), whats the best way get a bike started? Should I just keep kicking (20+ times?), and will using the choke fill up the float bowl...

Selling my CL350. I bought it last summer but dont really need it and have another CB350 i want to give some attention to. Here's the Parts list: Airtech Fiberglass Tank Airtech Fiberglass Seat Aluminum Rearsets (from Durgam) Progressive Shocks PMFR Steering Dampner with Fork Clamp Mount...

Hi, I pulled off the stator and points covers for the first time on a bike i purchased a while back to tune up before jetting carbs. This is what I found. does anyone have any information on either? I'm not sure how to adjust this ignition AND there is no tick mark on the stator so I am...

Selling headers for the CB350. Small crack at the end of the right pipe. (a bunch of pics below) I was running them as is, but they could be repaired real easily. I suspect these were made by Mike at 47fab but can't say for certain. Looking for $90 shipped in the USA Oh, and here is a video of...

Hey guys, I just extended these CL350 headers with straight tubing. Right now they are just bolted on with the exhaust studs. I plan on welding on tabs to each of the pipes to connect the two. How necessary is it though for another support at the end of the pipes? I've seen quite a few...

I bought this CB350 off CL recently for cheap and have fixed/finished some of the mechanical stuff but i still have some learning about getting it running right. It's got mikuni carbs. The motor does not start with the choke engaged. Without the choke engaged, the motor starts first or second...

I bought this seat from ebay a little while ago. While waiting for it to arrive though, I decided to take my build in a different direction and grinded off my seat mounts. The seat can be seen here A thread about them can be seen here This is a full seat, it's mounted using the original...

I'm looking for a seat thats similar to the Nitroheads tuck roll seat. I cant afford a $400 seat though... It's going on my 72 cb350, anyone have any suggestions before I make my own?