Search results

So I bough a little baby-sized SR - there is absolutely no possible way I can afford a 400/500 here in AUS. I'm looking $5G + for a rustbucket. This will be a cafe/bobber....Cobber.

Anyone able to identify the model of seat from Deus' Scorpio seen here http://au.deuscustoms.com/motorcycle/the-scorpio/ Shanks and sorry for another boring thread! -tried to ask Deus themselves but no real answer-

Hi guys! I have a 1988 (I think) Kawasaki GPX250 set of forks. The have a dual disk set up on a mag wheel. This model I believe http://classic-motorbikes.net/images/gallery/8356.jpg . I'm going to put these on another bike (sr250) which presently has a front spoke wheel, so I would like to...

Did a bit of a search here and on google but couldn't find any great answers - sorry if its already been answered. How will powdercoating or 2pak painting a n engine be? It's an air cooled sr250 - will it overheat. Also will I need to remove gaskets - will they be affected by the heat? Thanks...

I'm thinking of asking a buddy who is an artist to paint something on my tank. Has anyone tried hand painting on a tank? I thought it would be ok if I 2pac clear coat it after. Advice?

Hellooooo. This is my CX500 build. This will be my second attempt at customising a bike, and I have very little knowledge about anything. Painted satin black. Painted satin black by spray cans. Not happy! It's too cold and wet here in Sydney for the paint to properly dry so they will be...

Hi guys, just about to buy some new rubber. My stock tyres measure 110/90/18 and 100/99/19. Will Dunlop K70 400/18 and 350/19 fit? Interwebs says yes but just want to confirm! Thanks

Well my cx500 is on the way, and I'm going to get it blue slipped before I start butchering it. I need new tires to pass inspection, and so it got me thinking maybe I'll ditch the 18in and 19in comstars for a 16in rear and 18 front spoked wheel set. So my first question, is it worth ditching...

This was my first motorbike/first build. Nice reliabe and cheap for when I mess something (everything) up. Added a few goodies; Daytona Speedo, K&N Pods and a Nitroheads seat. [/url]

I'm replacing my old large battery on my bike. I've never replaced a battery before on his bike, and just wondering how I chose what battery. Do I just read the old one and buy the same? It's a 12v 9a, can I get a smaller 12v 6a or even a 4a? What will a change in amps or volts do? I have a kick...

Simple question; my carbs are 46mm on the inside, what size pod filters should I need? Do I go for a pod with a 47mm inside flange diameter and fit them, then tighten them up? Thanks!

So everyone I've spoken to has said to keep my 1976 Honda cj250t stock as a rock, get it rego'd, then to customise it. But what happens with I need to get I pink slip the next year? How do people pass their custom cafe conversions in NSW each year? Thanks!

Hello everyone! Well recently I bought a a 1976 Honda CJ250t but with the hope of finding a 360 engine. Can a just slap on a 360t engine if I happen to find one? How can one know if a bigger engine will fit ie a slightly later cb 400 engine? Please excuse the ridicules lack of knowledge (this...