joeschuit
Been Around the Block
Re: '75 suzuki gt250...Seat pad construction, pic heavy
I got a few more hours put in. I got the powerdynamo flywheel installed and timed. The oil pump system is now in. I think I'm going to pull the clutch cover so I can prime the pump rather than turning the motor over by hand. You can see the oil lines going to each of the crank bearings and cylinders. The center bearing is lubricated by the transmission oil.
Here it is with the covers on. You can see the relief I dremeled out of the pump cover for the throttlebodies.
With fresh gaskets, the throttlebodies are mounted. I can focus on the wiring and making up a new throttle cable. I used the original before, but I only need a 1 to 2 splitter, not a 1-3.
I got a few more hours put in. I got the powerdynamo flywheel installed and timed. The oil pump system is now in. I think I'm going to pull the clutch cover so I can prime the pump rather than turning the motor over by hand. You can see the oil lines going to each of the crank bearings and cylinders. The center bearing is lubricated by the transmission oil.
Here it is with the covers on. You can see the relief I dremeled out of the pump cover for the throttlebodies.
With fresh gaskets, the throttlebodies are mounted. I can focus on the wiring and making up a new throttle cable. I used the original before, but I only need a 1 to 2 splitter, not a 1-3.