http://www.examiner.com/article/vintage-honda-keihin-carburetors
The Keihin carburetor has been a fixture on Honda Motorcycles since the late 1950s. Before that , many Japanese bike manufacturers had used licensed copies of Amal carburetors on many models. Keihin developed a fairly standardized carburetor design, which was applied to most Honda models from the 50cc C110 Sports Cub to the mighty CB750 Fours. The popular 250-305cc models from the 1960s carried either 22mm or 26mm versions on nearly 250,000 motorcycles. The history of these two sizes can fill a small booklet, though, as Honda applied fuel metering theories differently in seemingly similar applications.
The 22mm carburetor has the most to talk about here, though, thus it is the subject of today’s topic. The first units are described as “round bowl” designs, where the float chambers had somewhat rounded corners and used rounded floats, as well. See illustrations for comparisons.
Initially, the 22mm carburetor was used on the 250-305cc Dream models, which were low-performance bikes with a 360 degree crankshaft firing order. Other than a few minor jet/needle changes, the carbs were the same for either model.
In 1961, the CB72-77 Super Sport models were released and two 22mm carburetors were used on the 250cc edition. A big design departure, however was use of a “power jet” system, to enrich the mixture above 6,000 rpms. This required additional external castings to provide the installation of fuel and air correction jets. Clean air needed to be drawn into the metering circuits, so a small extension tube was created, which was connected to the air filter fitting, using a small rubber tube. Changing the sizes of the fuel and air correction jets allowed for fine tuning of the high-speed circuits, which was critical in an engine that was turning 9,000 rpms back then.
Ironically, when the new 250cc Scrambler was introduced in 1962, the same 22mm carburetors were used, but the power jet circuit castings were all left un-machined and just the main jet size was increased to fuel the high speed circuits. Throughout production of both models, each had its own carburetor designs, despite the similarity in the engine configurations. By 1965, however, carburetors switched from round bowl to square bowl design on CA/CB models, but for some reason all Scramblers had square bowl units, dating back to 1962.
The 26mm carburetors of the CB/CL77s were offered as round bowl and square bowl designs, through the years, but the early castings still offered power jet extensions and protrusions, which were never used. Finally, in the final year of production, the excess material was removed, so the carburetor bodies have a much smoother appearance. Eventually, the 26mm carburetors were modified to become 28mm-sized for the early CB750 K0 models (4 cable style) and also revamped into a 24mm pair, fitted to the later SL350 models.